BAZ series Monoblock Centrifugal pumps
Temperature of water≤80℃, suction pressure≤1kg/cm2, working pressure is 1.6Mpa.
Temperature of water≤100℃, suction pressure≥2kg/cm2, working pressure is 1.6Mpa.
Temperature of water≤120℃, suction pressure≥4kg/cm2, working pressure is 1.6Mpa.
Application Std： Flange std can be BS,DIN,ISO,etc
INNOVATION:
•There are four wheels installed on the base plate to make sure the pump can be repaired quick and easily.
•If capacity is bigger than 400m3/h, the double volute is used to balance the radial force and increase the service time of the bearing(at least 2 times)
•The direction of suction/discharge can be on the top at the same time.
•The pump can be used to mixed cool and hot water, so Heat exchange plate is not necessary to use.
Remarks: We have been OEM for many brands from Europe and our pumps has been used by famous brands from T BAZ series is innovated monoblock pump used in HVAC area.
Constructure
| 1 | Base plate | 2 | Sliding wheels | 3 | Pin shaft | 4 | Support | 5 | Screw | 6 | Safty screw | 7 | Two end screws |
| 8 | Screw | 9 | Two end screws | 10 | Screw nut | 11 | Eletric motor | 12 | Water slinger | 13 | Mechanical seal | 14 | Bolts |
| 15 | Pump cover | 16 | Impeller | 17 | Pump casing | 18 | Key | 19 | Impeller nut | 20 | Nuts | 21 | Bolts |
| 1. Bolt | 2. Cornical plug | 3. Two end screws | 4. Nut | 5 impeller nut | 6. Key | 7. Pump casing |
| 8. Impeller | 9. Corrosion proof cover | 10. Front static o-ring seat | 11. Bolt | 12. Connection pipe | 13. Mechanical seal . | 14. Casing cover |
| 15. Rear o-ring seat | 16. Bolt | 17. Two end bolts. | 18. Nut | 19. Water slinger | 20. Electric motor | 21 bolt |
| 22. Screw | 23. Two end screw | 24 safty plug | 25. Support | 26. Plug shaft | 27. Wheels | 28. Base plate. |
| 1 | PUMP CASING | 2 | DISCHAEGE RUBBER PIPE | 3 | CONNECTED PIPE | 4 | CASING COVER |
| 5 | THREE WAYS CONNECTION | 6 | INLET RUBBER PIPE | 7 | CONNECTOR | 8 | BALL VALVE |
